Multifunction Digital Display

Activating/Deactivating Display Data (TRP, AVS, LAP, CLK, etc.)

Note: Your odometer display (ODO) cannot be disabled!

  • Turn key to on position and start the bike to activate the headlight. Since it's not necessary to keep the bike running, use the kill switch.
    • To cycle between available display data, press SCROLL as one normally would.
    • To add all of the possible display data, which includes a trip counter, maximum speed, average speed, two lap timers, two clocks, and perhaps some other stuff, select the ODO, press and hold SCROLL until "WS" appears in the lower right hand corner of the display (roughly 15 seconds), and continue holding SCROLL. Now, flash the headlight high beams 5 times, and after a moment the "WS" will flash. Release SCROLL and all of the display data will have been enabled.
    • To disable the currently selected display data, do the same procedure as adding display data, but select a display other than ODO.

Setting the Display Units (mph or km/h)

  • Press and hold SCROLL, turn key to on position, and continue holding SCROLL until "WS" appears in the lower right hand corner of the display.
  • Press SCROLL to cycle through available settings until "Mph" and "Km/h" appears on the right hand side of the display, and then press and hold SCROLL for 5 seconds to confirm your selection.
  • The "Mph" will start flashing. Press SCROLL to switch between the two.
  • Press and hold SCROLL for 5 seconds to store the setting.

Setting the Red Line Warning Light

  • Press and hold MODE and SCROLL at the same time for more than 5 seconds. The display will show "00000"; the first digit will be flashing.
  • Press MODE to increase the flashing digit by one unit. Waiting two seconds will advance the cursor by one digit.
  • Press and hold SCROLL for more than 2 seconds to store the setting.

Resetting Oil Service Indicator (Oil Can Icon)

  • Press and hold SCROLL, turn key to on position, and continue holding SCROLL until "WS" appears in the lower right hand corner of the display.
  • Press SCROLL to cycle through available settings until the oil service icon (oil can) appears, and then press and hold SCROLL for 5 seconds to confirm your selection.
  • The display will show "NO" which will be flashing. Press SCROLL to switch to "YES" which indicates that you have performed the service and want to reset the notification, and then press and hold SCROLL for 5 seconds to confirm your selection.
  • The display will show four digits, which are the number of operational hours before the service icon will reappear; an entry of "0000" will disable the icon entirely. The first digit will be flashing. Press SCROLL to increase the digit by one unit. Waiting 5 seconds will advance the cursor by one digit.
  • Press and hold SCROLL for 5 seconds to store the setting.

Resetting General Service Indicator (Wrench Icon)

  • Press and hold SCROLL, turn key to on position, and continue holding SCROLL until "WS" appears in the lower right hand corner of the display.
  • Press SCROLL to cycle through available settings until the general service icon (wrench) appears, and then press and hold SCROLL for 5 seconds to confirm your selection.
  • The display will show "NO" which will be flashing. Press SCROLL to switch to "YES" which indicates that you have performed the service and want to reset the notification, and then press and hold SCROLL for 5 seconds to confirm your selection.
  • The display will show "Km/h" or "Mph" which indicates the units this setting will use. Press SCROLL to cycle between the two units, and then press and hold SCROLL for 5 seconds to confirm your selection.
  • The display will show 5 digits which are the number of kilometers or miles (whichever you selected) before the service icon will reappear; an entry of "00000" will disable the icon entirely. The first digit will be flashing. Press SCROLL to increase the digit by one unit. Waiting 5 seconds will advance the cursor by one digit.
  • Press and hold SCROLL for 5 seconds to store the setting.

Thanks for visiting! Please feel free to contact me on ApriliaForum, or you may contribute directly by following the instructions on the main page.

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-Share Alike 2.5 License.